Jump to: navigation, search

GVP MCP:sip:referxferwaitnotifyother
 
(13 intermediate revisions by 2 users not shown)
Line 4: Line 4:
 
|valid=sip.referxferwaitnotifyother should be a non-negative integer, greater then 100 and less than or equal to the maximum integer as defined by the Genesys Administrator Help.
 
|valid=sip.referxferwaitnotifyother should be a non-negative integer, greater then 100 and less than or equal to the maximum integer as defined by the Genesys Administrator Help.
 
|takeseffect=At start/restart
 
|takeseffect=At start/restart
−
|shortdesc=For internal use.
+
|shortdesc=Wait for the second leg NOTIFY. This specifies a timeout value to wait for the NOTIFY message on the second leg, before signaling the disconnection on the parent leg. This parameter is active when [sip] referxfertryoutbound = 1. Values are specified in millisecond.
 
}}
 
}}
 
{{DraftOption}}
 
{{DraftOption}}
 +
 
{{PubExtended}}
 
{{PubExtended}}
 +
 
{{DraftExtended}}
 
{{DraftExtended}}
 +
 
{{OptionCreate
 
{{OptionCreate
 
|component=GVP_MCP
 
|component=GVP_MCP
Line 16: Line 19:
 
|section=sip
 
|section=sip
 
|parameter=referxferwaitnotifyother
 
|parameter=referxferwaitnotifyother
 +
|groupid=grpSIP
 +
|groupname=SIP
 +
|format=numeric
 +
|displayname=Refer Transfer Wait Notify Other
 
}}
 
}}
  
 
[[Category:GVP_MCP_options]]
 
[[Category:GVP_MCP_options]]

Latest revision as of 14:02, September 24, 2019



View in ref guide.

Edit this option          Publish this option          Clear draft content


Published Option

referxferwaitnotifyother

Default Value: 500
Valid Values: sip.referxferwaitnotifyother should be a non-negative integer, greater then 100 and less than or equal to the maximum integer as defined by the Genesys Administrator Help.
Changes Take Effect: At start/restart


Wait for the second leg NOTIFY. This specifies a timeout value to wait for the NOTIFY message on the second leg, before signaling the disconnection on the parent leg. This parameter is active when [sip] referxfertryoutbound = 1. Values are specified in millisecond.

Draft Option

No draft option

This page was last edited on September 24, 2019, at 14:02.
Comments or questions about this documentation? Contact us for support!