Jump to: navigation, search

GVP MCP:mpc:opus-packetloss

(Karlabel used the OptionClear action.)
 
(8 intermediate revisions by 2 users not shown)
Line 5: Line 5:
 
|takeseffect=Immediately/session
 
|takeseffect=Immediately/session
 
|shortdesc=Used to indicate the expected packet loss percentage to the Opus encoder. The range is 0 to 100, inclusive. Higher values will give progressively more loss resistant behavior, at the expense of quality at a given bitrate in the lossless case, but greater quality under loss. The default value is 20, implying 20 percent packet loss is expected.
 
|shortdesc=Used to indicate the expected packet loss percentage to the Opus encoder. The range is 0 to 100, inclusive. Higher values will give progressively more loss resistant behavior, at the expense of quality at a given bitrate in the lossless case, but greater quality under loss. The default value is 20, implying 20 percent packet loss is expected.
 +
 
}}
 
}}
 
{{DraftOption
 
{{DraftOption

Latest revision as of 15:59, June 29, 2020



View in ref guide.

Edit this option          Publish this option          Clear draft content


Published Option

opus.packetloss

Default Value: 20
Valid Values: A number between 0 and 100 inclusive.
Changes Take Effect: Immediately/session


Used to indicate the expected packet loss percentage to the Opus encoder. The range is 0 to 100, inclusive. Higher values will give progressively more loss resistant behavior, at the expense of quality at a given bitrate in the lossless case, but greater quality under loss. The default value is 20, implying 20 percent packet loss is expected.

Draft Option

No draft option

This page was last edited on June 29, 2020, at 15:59.
Comments or questions about this documentation? Contact us for support!