GVP MCP:cpa:outbound-native-initialstate
| (7 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|valid=Choose between: preconnect or postconnect | |valid=Choose between: preconnect or postconnect | ||
|takeseffect=Immediately/session | |takeseffect=Immediately/session | ||
| − | |shortdesc=When native CPA is used for outbound calls, this option specifies the initial CPA state. preconnect - detection will start as soon as the call is initiated, and detection of preconnect and postconnect events will be enabled. postconnect - detection will start when the call is connected, and only detection of postconnect events will be enabled. | + | |shortdesc= |
| + | When native CPA is used for outbound calls (for bridge transfers and "remdial" requests), this option specifies the initial CPA state. | ||
| + | NOTE: this option does not apply to SSG (Supplementary Services Gateway) or OCS (Outbound Contact Server) initiated calls. | ||
| + | preconnect - detection will start as soon as the call is initiated, | ||
| + | and detection of preconnect and postconnect events will be enabled. | ||
| + | postconnect - detection will start when the call is connected, | ||
| + | and only detection of postconnect events will be enabled. | ||
| + | |||
}} | }} | ||
{{DraftOption}} | {{DraftOption}} | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
{{PubExtended}} | {{PubExtended}} | ||
| − | |||
| − | |||
| − | |||
| − | |||
{{DraftExtended}} | {{DraftExtended}} | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
{{OptionCreate | {{OptionCreate | ||
Latest revision as of 15:32, June 29, 2020
View in ref guide.
Edit this option Publish this option Clear draft content
Published Option
Draft Option
No draft option
This page was last edited on June 29, 2020, at 15:32.
Comments or questions about this documentation? Contact us for support!