GVP MCP:mpc:tiasfraction
| (6 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|valid=tiasfraction is a percentage (out of 100) that must be an integer of value 0 or greater. | |valid=tiasfraction is a percentage (out of 100) that must be an integer of value 0 or greater. | ||
|takeseffect=At start/restart | |takeseffect=At start/restart | ||
| − | |shortdesc=When the TIAS bandwidth parameter is specified on incoming SDP, mpc.tiasfraction specifies the percentage of the TIAS bitrate that the MPC will try to achieve on the outbound media stream. If tiasfraction is 100 (default) then the MPC will try to limit the media bitrate to TIAS. In some cases it might go slightly over the TIAS limit (by perhaps one or two percent), so for safety it might be better to specify a tiasfraction value somewhat less than 100. It is possible to specify a tiasfraction greater than 100, but this is not recommended. | + | |shortdesc=When the TIAS bandwidth parameter is specified on incoming SDP, mpc.tiasfraction specifies the percentage of the TIAS bitrate that |
| + | the MPC will try to achieve on the outbound media stream. If tiasfraction is 100 (default) then the MPC will try to limit the media bitrate | ||
| + | to TIAS. In some cases it might go slightly over the TIAS limit (by perhaps one or two percent), so for safety it might be better | ||
| + | to specify a tiasfraction value somewhat less than 100. It is possible to specify a tiasfraction greater than 100, but this is not recommended. | ||
| + | |||
}} | }} | ||
{{DraftOption}} | {{DraftOption}} | ||
Latest revision as of 15:41, June 29, 2020
View in ref guide.
Edit this option Publish this option Clear draft content
Published Option
Draft Option
No draft option
This page was last edited on June 29, 2020, at 15:41.
Comments or questions about this documentation? Contact us for support!