GVP MCP:mpc:cpa-detectstatenolimitbuffdur
| (6 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|valid=A valid no limit buffer duration must be a numeric not less than 20 | |valid=A valid no limit buffer duration must be a numeric not less than 20 | ||
|takeseffect=At start/restart | |takeseffect=At start/restart | ||
| − | |shortdesc=Specifies buffer duration (msec) for CPA when a detection state timeout is unlimited. When the buffer is full due to no signal has been detected, a buffer limit event will be thrown. Enforced minimum value is 20 msecs. | + | |shortdesc=Specifies buffer duration (msec) for CPA when a detection state |
| + | timeout is unlimited. When the buffer is full due to no signal has been detected, | ||
| + | a buffer limit event will be thrown. Enforced minimum value is 20 msecs. | ||
| + | |||
}} | }} | ||
{{DraftOption}} | {{DraftOption}} | ||
Latest revision as of 15:47, June 29, 2020
View in ref guide.
Edit this option Publish this option Clear draft content
Published Option
Draft Option
No draft option
This page was last edited on June 29, 2020, at 15:47.
Comments or questions about this documentation? Contact us for support!