GVP MCP:mpc:cpa-preconn tones det mode
| Line 4: | Line 4: | ||
|valid=Choose between: 0 or 1 | |valid=Choose between: 0 or 1 | ||
|takeseffect=At start/restart | |takeseffect=At start/restart | ||
| − | |shortdesc=Specifies the mode for the detection of preconnect tones. By default, the preconnect tones will only be detected in preconnect state. Optionally, the detection can be configured to operate in preconnect and postconnect state. 0 - Preconnect state only 1 - Preconnect and postconnect state NOTE: This option only applies to tones, carrier message detection (Voiceprint) during preconnect phase is not affected, that is, by setting this option to 1 (Preconnect and postconnect state) will not make MCP detect carrier messages at postconnect phase. | + | |shortdesc= |
| + | Specifies the mode for the detection of preconnect tones. By default, the preconnect | ||
| + | tones will only be detected in preconnect state. Optionally, the detection can be | ||
| + | configured to operate in preconnect and postconnect state. | ||
| + | 0 - Preconnect state only | ||
| + | 1 - Preconnect and postconnect state | ||
| + | NOTE: This option only applies to tones, carrier message detection (Voiceprint) | ||
| + | during preconnect phase is not affected, that is, by setting this option to 1 | ||
| + | (Preconnect and postconnect state) will not make MCP detect carrier messages at | ||
| + | postconnect phase. | ||
| + | |||
}} | }} | ||
{{DraftOption}} | {{DraftOption}} | ||
Latest revision as of 15:48, June 29, 2020
View in ref guide.
Edit this option Publish this option Clear draft content
Published Option
Draft Option
No draft option
This page was last edited on June 29, 2020, at 15:48.
Comments or questions about this documentation? Contact us for support!