Jump to: navigation, search

GVP MCP:mpc:cpa-preconn tones det mode
Line 2: Line 2:
 
|hidden=false
 
|hidden=false
 
|default=0
 
|default=0
−
|valid=
+
|valid=Choose between: 0 or 1
 
|takeseffect=At start/restart
 
|takeseffect=At start/restart
−
|shortdesc=Specifies the mode for the detection of preconnect tones. By default, the preconnect tones will only be detected in preconnect state. Optionally, the detection can be configured to operate in preconnect and postconnect state.
+
|shortdesc=Specifies the mode for the detection of preconnect tones. By default, the preconnect tones will only be detected in preconnect state. Optionally, the detection can be configured to operate in preconnect and postconnect state. 0 - Preconnect state only 1 - Preconnect and postconnect state
 
}}
 
}}
 
{{DraftOption}}
 
{{DraftOption}}
 +
  
 
{{PubExtended}}
 
{{PubExtended}}
 +
 
{{DraftExtended}}
 
{{DraftExtended}}
 +
  
 
{{OptionCreate
 
{{OptionCreate

Revision as of 20:27, November 23, 2017




View in ref guide.

Edit this option          Publish this option          Clear draft content


Published Option

cpa.preconn_tones_det_mode

Default Value: 0
Valid Values: Choose between: 0 or 1
Changes Take Effect: At start/restart


Specifies the mode for the detection of preconnect tones. By default, the preconnect tones will only be detected in preconnect state. Optionally, the detection can be configured to operate in preconnect and postconnect state. 0 - Preconnect state only 1 - Preconnect and postconnect state NOTE: This option only applies to tones, carrier message detection (Voiceprint) during preconnect phase is not affected, that is, by setting this option to 1 (Preconnect and postconnect state) will not make MCP detect carrier messages at postconnect phase.

Draft Option

No draft option

Comments or questions about this documentation? Contact us for support!